Auricast Manuals· Administration Manual

STL Links

An STL link carries a program from the studio to the transmitter site. Auricast does it with a small receiver at the site that takes the program over the internet, so the link needs no cable or radio path between the two places. The STL Links card is at the bottom of Setup → Outputs & Streams.

How It Works

The receiver is a Raspberry Pi, or a PC with a USB sound card, running the auricast-stl program. It calls out to the station, so neither site opens a port. The station sends the program as Opus audio over WebRTC. The receiver plays it on its sound card into the transmitter.

With no audio from the link for a few seconds, the receiver plays its own fallback folder of music instead, and goes back to the link by itself.

Pair A Receiver

  1. Install auricast-stl on the receiver, following its own installation notes.
  2. On the STL Links card, press Pair A Receiver. A one-time pairing command appears, in the form sudo auricast-stl pair <station address> <code>.
  3. Run that command on the receiver.

The receiver appears on the card with its name. Remove Receiver forgets it; it has to be paired again to take a link.

When a receiver is online the card shows how it is doing: its buffer against its target, the peak level, packets lost, underruns and corrections. Settings for its link:

SettingWhat it does
ProgramWhich program the link carries, usually the transmitter program
AudioAfter Stereo Tool (the default) or Before Stereo Tool. Choose Before when the receiver runs Stereo Tool itself
RateThe link's bitrate. Higher is better quality and uses more data
BufferA safety buffer. A longer one rides out a rough connection; a shorter one means less delay
OutputLeft And Right, or MPX (FM Composite) for a transmitter with a composite input. MPX needs a sound card that plays 192 kHz
PathDirect, Tailscale or TURN relay. See below
Sound deviceWhich of the receiver's sound devices to play on. It reports its own list. The default is the receiver's default
Fallback folderThe folder on the receiver that plays when the link is silent

Choosing The Path

Stereo Tool On The Receiver

The receiver can run Stereo Tool at the site. Tick Stereo Tool on the receiver, then use the same steps as Processing: Download From Thimeo (it downloads to the receiver, which must be online), Save Key, Upload Preset, and Open Stereo Tool, Save To Preset and Discard Changes once it is on. A badge shows whether it is processing, bypassed or off. The receiver needs its own Stereo Tool key.

A MPX output uses Stereo Tool's composite signal. If the card warns that samples go over full scale, lower Stereo Tool's FM output level.